CIUS on CUCM 8.5.1.11900

[cjrchoi11]

Hi,

As per Cius data sheet, it supports on CUCM8.5.1 and 8.6 but I cannot find a device option "Cisco Cius" on CUCM8.5.1 even I installed Cius COP file.

How to configure Cius device on CUCM8.5.1.11900 (unrestricted)?

Thanks in advance,

[Jaime Valencia]

Have you done a cluster reboot after installing the cop file?

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

[adbaker]

You don't need to do a cluster reboot after installing the cop file, just restart the TFTP service on all servers running this service in the cluster. Once complete the CIUS should appear in the device drop-down list.

[Vipul Jindal · Accepted solution]

you need to install the latest device pack as well. you can find the device pack on the cisco.com.

thanks,

Vipul jindal

[cjrchoi11]

Thanks Vipul, resolved by installing latest device pack.

[simon.maclean]

Guys,

I have a Cius and trying to connect to UCM. Where is best place to find installation guide?

UCM is 7.13, but i understand minimum version is 7.15?

What are the settings for registering within the UCM?

Any help much appreciated.

[Jaime Valencia]

The way to configure the CIUS is exactly the same as any other phone.

Add new phone -> CIUS -> MAC address and your regular settings (DP, security mode, etc) then add the DN.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

[adbaker]

Use the Ethernet MAC not the wireless MAC, regardless of your connection media. The CIUS uses the Ethernet MAC during registration.

[simon.maclean]

Thanks for all your help. CIUS is registered to UCM 8.6 now, but getting rejected on the registration? Can see the registration on the UCM with an ip address. any ideas?

[adbaker]

On first registration the CIUS looks to have registered but the telephony isn't available for some time (a few minutes) whilst it upgrades firmware etc. If it st