cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
390
Views
0
Helpful
1
Replies

CLID Issue.

Rajan R
Level 1
Level 1

Hey Guys,

We have a h323 gateway on a 2921 and CUCM8.6 on VM. We have the pilot as XXXX7500. and 300 numbers there on. When an outside user calls a dn it displays XXXX7500 on the IP Phone of the user. But sometimes it displays the correct calling number aswell. Why could this be ? We have not configured any translations.

Thanks

Varadarajan.R

1 Reply 1

Cesar Ortega
Level 1
Level 1

Check on the CM the route group (just above route pattern access path). There is a section named "Calling Party Transformation", it should be empty, i.e., no transformations at all.

Regards,

Cesar

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: