CM 5.1 7915 Problem

[stevo1664]

Hello

I have a 7915 Sidecar attached to a 7962G and it will not boot it it stuck on Orange Lights.

I have read many posts about device and sidecar OS versions so I have upgraded to the following, but the problem has not been fixed:

Here are the versions I am running:

Call Manager - 5.1.3.4000-4 [i.e. 5.1 (3c)]

7962G - SCCP42.8-5-3S

7915 - B015-1-0-4

The phone's webpage shows no Expansion Module attached.

This is happening on two phones so I don't think it is faulty equipment.

Another small issue, is that I am not sure which of the following options I should set the expansion module to in CM, as far as I know there is only one module and it has 2 pages of 12 buttons:

7915 12-Button Line Expansion Module

7915 24-Button Line Expansion Module

In any case I have tried it with both options without success.

Has anyone experience of my problem? Can anyone advise me how I can go about troubleshooting?

Many Thanks

Steve

[htluo]

I might be wrong.  But I don't think the CUCM version you're running recognize 7915.  You should try to download the latest device pack and install it on CUCM.

Hope this helps!

Michael

http://htluo.blogspot.com

[stevo1664]

Hello thanks for trying to help. I believe it should be supported.

From the datasheet http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps379/data_sheet_c78-468672.html

Table 4:

Phone Software Requirements: 8.3(5) and later

Call-Control Compatibility: Cisco Unified Communications Manager 4.2(3) SR3a, 4.3(2), 5.1(3)b, 6.1(1), 7.0, 7.1 and later; Cisco Unified Communications Manager Express 4.3/7.0 and later. Cisco Unified Survivable Remote Site Telephony (Unified SRST) 4.1 (IOS 12.4.15T) and later.

Signalling protocols: Skinny Client Control Protocol (SCCP) Software 8.3(5) and later, Session Initiated Protocol (SIP) Software 8.4(1) and later

[Yue bun Yuen]

hello, Is this problem solved?