Asim,
You may be hitting this bug
CME 7.1 GUI doesn't shows the ephone with ID beyond the "max-ephones"
Symptom:
If customer configure the Max-ephone 100 under Telephony-system, the CME GUI only shows the ephone with ID that below 100. The CME GUI does not shows any ephone with ID that above 100.
Notes, the ephone ID is not relevant with max-ephones configuration. Customer can assign any ID to ephone. The "max ephones" command should only limited the max ephone can be registered to the system.
Conditions:
Environment:
CME: 7.1
GUI: 7.1
Workaround:
Ensure the ephone ID is smaller than the value be configured in "max-ephones".
Details
Known Affected Releases: (1)
12.4(22)T
Known Fixed Releases: 0
No release planned to fix this bug
Product: Cisco Unified Communications Manager Express
Regards,
Alex.
Please rate useful posts.
Regards,
Alex.
Please rate useful posts.