cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
161
Views
0
Helpful
1
Replies

cme and analogic cordless

gevangelista
Beginner
Beginner

Good morning  I've installed, configured and connected  to an fxs port one cordless.

I've assigned to this phone the same  switchboard extension.

In this mode  whn the  incoming call arrive on the switchboard  the ipphone rinnging and ringing also the cordless.

I check  all but the cordless doesn't ringing.

I've created the following configuration:

voice-port 0/3/1

compand-type-a-law

cptone IT

bearer-cap Speach

!

dial-peer voice 551 pots

destination-pattern 551

port 0/3/1

!

ephone-dn 51 dual-line

number 551

pickup-group 10

label 551

name 551

call-forward noan 11111 timeout 12

!

ephone 15

mac-address aaaa.bbbb.cccc

username "pippo" passwrod 1234

paging-dn 10

type 7960

button 1:51

!

ephone-hunt  1 sequential

pilot 11111

list 552, 531, 557

final 551

timeout 10, 10,10

can you help me to solve this little  item?

thanks in advance

regards

giancarlo

1 Reply 1

acampbell
Advocate
Advocate

Giancarlo,

If you want to control the phone on an FXS port on CME you will

have to bring the FXS port under SCCP control.

Look at these 2 links

CME admin guide

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebasic.html#wp1046471

Enabling SCCP gateway (FXS)

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsbasic_ps10592_TSD_Products_Configuration_Guide_Chapter.html#wp1010395

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: