Hi all,
I have a CME on which SIP call arrives which I forward to CUE where I have IVR configured. This IVR plays some messages and offers some choices, however none of the digits I press on my phone comes to CUE.
Call flow: PSTN - CME - CUE
CME receives DTMF as inband and I can clearly see the digit signals when I take tcp dump on CME. I have transcoder configured and on DP to CUE I have dtmf relay sip notify. Also on DP to CUE I have g711ulaw while on inbound DP on which call arrives I have g711alaw. So since call connects I figure my transcoder is working, however DTMF is clearly not being transcoded. So why is my transcoder not transcoding DTMG but it's transcoding from g711alaw to g711ulaw?
radio-cme#sh dspfarm profile 1
Dspfarm Profile Configuration
Profile ID = 1, Service =Universal TRANSCODING, Resource ID = 1
Profile Service Mode : Non Secure
Profile Admin State : UP
Profile Operation State : ACTIVE
Application : CUBE Status : ASSOCIATED
Resource Provider : FLEX_DSPRM Status : UP
Total Number of Resources Configured : 16
Total Number of Resources Available : 16
Total Number of Resources Out of Service : 0
Total Number of Resources Active : 0
Codec Configuration: num_of_codecs:5
Codec : pass-through, Maximum Packetization Period : 0
Codec : g711ulaw, Maximum Packetization Period : 30
Codec : g711alaw, Maximum Packetization Period : 30
Codec : g729ar8, Maximum Packetization Period : 60
Codec : g729abr8, Maximum Packetization Period : 60
I've attached sh run and debug ccsip for one test call. I changed calling number to 1001, and I deleted some info from sh run which I dont wanna disclose.
Appriciate any help in regards to this issue.
