05-04-2012 04:34 AM - edited 03-16-2019 10:58 AM
Hi guys,
I have a problem with a BLF configuration on a CME 8.6.
The Problem is that the icon for BLF is a keypad and NOT a phone icon.
Also under "#sh presence subscription summary" the 611 and 619 are not shown.
I have also a 7961 with a 7914 Module which works without issues.
Here is the config:
presence
presence call-list
max-subscription 144
watcher all
allow subscribe
!
sip-ua
presence enable
!
ephone-dn 63 dual-line
number 611
pickup-group 1007
mobility
snr 001234567890# delay 10 timeout 60 cfwd-noan 605
allow watch
call-forward noan 805 timeout 10
!
ephone-dn 64 dual-line
number 619
pickup-group 1007
mobility
snr 009876543210# delay 10 timeout 60 cfwd-noan 605
allow watch
call-forward noan 805 timeout 10
no forward local-calls
!
ephone 16
blf-speed-dial 1 611 label "611"
type 7961
button 1:16 2s17 3:64 4o44,53
!
ephone 17
device-security-mode none
blf-speed-dial 1 619 label "619"
type 7961
button 1:17 2s16 3:63 4o44,53
...any ideas?
Thanks a lot.
Cristian
05-04-2012 04:39 AM
can you try
ephone 17
no button 3:63
restart
05-04-2012 04:46 AM
Hi Paolo,
ok. done.
and now?
Thanks.
05-04-2012 06:35 AM
And now check if the phone show over keypad for blf-speed-dial.
05-04-2012 06:38 AM
same problem.
the keypad is still displayed.
I have added and re-added the button more than one time but still the same...
Thanks.
05-04-2012 06:59 AM
Problem solved: cable unplugged/plugged back in.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: