cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1150
Views
0
Helpful
1
Replies

CME Caller ID and Incoming Calls Problem

Andres Franco
Level 1
Level 1

Hello everybody, first of all, my best wishes to all of you this Christmas.

Ok, I have the following scenario. A Cisco ISR 2811 with CME 7.1 and IOS 12.24T working with third party SIP phones. The IP phones can call each other, can make and receive calls from the PSTN and transfer is working Ok. One of the problems I have is that any incoming call shows the IP address of the router instead of the caller ID and I don´t know how to fix it in this scenario. Secondly, when there is an incoming call, the hunting group feature under sip works great, but the phones keep ringing besides the caller (my self testing from my mobile) has stopped calling. This is also true with the PLAR pointing to a single IP phone instead of the Pilot for the HG. Any ideas or suggestions? I´m attaching the config, so you can take a look. Thanks in advance.


1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Issue 1, search "FXO caller ID".

Issue 2, search "disconnect supervsion".

Both have many, many threads with all the info needed.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: