cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
275
Views
0
Helpful
1
Replies
Highlighted
Beginner

CME Cisco 8861

Have fully function Cisco Call Manager Express, running 20 phones SCCP 7961 mainly.

Have purchased some new 8800 series phones 8861, 8821, and 8831.

Trying to get the 8861 registered with my CME.

My config is as follows:

voice service voip
 ip address trusted list
  ipv4 x.x.x.x
  ipv4 y.y.y.y
 cti csta mode basic
 no cti shutdown
 allow-connections sip to sip
 no supplementary-service sip moved-temporarily
 no supplementary-service sip handle-replaces
 fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
 sip
  registrar server

voice register pool-type  8821
 phoneload-support
 reference-pooltype 9971
voice register global
 mode cme
 source-address internalIPAddr port 5060
 max-dn 96
 max-pool 24
 load 8861 sip88xx.11-7-1-17.loads
 load 8821 sip8821.11-0-3SR1-1.loads
 create profile sync 0445144314544414
 auto-register
  password XXX
  auto-assign 1001 to 1010
 !
voice register dn  48
 number 3333
voice register dn  49
 number 3333

voice register pool  23
 busy-trigger-per-button 2
 id mac 0059.DCDE.036C
 type 8861
 number 1 dn 48
voice register pool  24
 id mac 00A2.89FB.A3EA
 type 8821
 number 1 dn 49

IOS - Version

System image file is "flash:c2900-universalk9-mz.SPA.156-3.M1.bin"

Phone just sits saying Phone is Registering.

Status messages:

TFTP AppDialrules.xml

Error updating Network Locale

Error updating User Locale

VPN not configured

SEPXXXXX.cnf.xml

Phone version 8861:

Active Load sip88xx.11-7-1-17

What am I missing?

Everyone's tags (1)
1 REPLY 1
Enthusiast

Delete the voice register

Delete the voice register config and amend as below for voice register global.

voice register global
mode cme
source-address internalIPAddr port 5060
max-dn 96
max-pool 24
tftp-path flash:
authenticate register
auto-register
password XXX
auto-assign 1001 to 1010

Do the same config for voice register dn and pool. Rest of the config seems to be fine.

After doing the config for voice register global, pool and dn, go back to voice register global and run the command for create profile.

Hope this helps.

Regards

Abhay

Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards