CME GUI not working

[monasir]

I'm having this problem with my callmanager express.

I am not able to reach the GUI of CME in my browser.

What could be the problem?

I have copied all of my html files to the flash of my CME site router.

I made a directory in flash (GUI) inside this folder copied all the html files.

ip http server

ip http path flash:/GUI

telephony service

web admin system name admin pass cisco

dn-webedit

I'm using the voice vlan interface (10.10.201.1) for the GUI not working

any help would be appreciated

[Gaurav Purohit]

Hello,

with "not working" what exaclty you mean, plz try and be specific? does the request gets timed out? whats the response code? you think there is any firewal?

[monasir]

Sorry for the miscommunication.

What i meant with not working is:

The GUI is not reachable after i have configured the CME telephony-service for GUI accesibility.

I am not using a firewall

Page cannot be displayed (IE)

[Jorge Armijo]

Hi,

-Is there any "http class" on the configuration? That sometimes brakes the GUI, if so, remove it.

-Can you ping that IP Address from your computer?

-Please remember: http://10.10.201.1/ccme.html

-Any access-list on the interface?

-Check if ip http secure-server is enabled and disable it

Let us know how it goes.

--

Jorge Armijo

[monasir]

Thanks for the replys.

I'm going to try this later seems i have another problem nowe.

i deleted the ios on my flash router accidently.

I have to fix this nowe with the tftpdnld rommon procedure.

Because when i boot my cisco router it says " canot load boot flash"

I'm using a tftp server to copy the flash back in my cisco router after the procedure it gives TFTP timed oud.

Hours of troubleshooting very painful job.

[chrysostomos1980]

Hi

Instead of the tftp proccess personally i am using a card reader , i put into the card reader the flash , and i have move in the flash a lot of files in less than 5 minutes