CME Hunt Group Timer Issues

[johnsnave1]

Hi, I have attempted to enter the following commands from cli under CME voice hunt group config but rejected with - invlaid input screen message:

max-timeout

timeout 5, 5

please see the config extract + attached screen shots for show version, show telephony service and screen errors.

I would be most grateful for any help or insight into this problem.

voice hunt-group 1 sequential
final 500
list 201,202
timeout 11
pilot 200

ephone-dn 593 octo-line
call-waiting ring
number 201 no-reg primary
pickup-group 1
label
name MainOffice One
call-forward busy 500
call-forward night-service 500
call-forward noan 500 timeout 20
night-service bell

ephone-dn 595 octo-line
number 202 no-reg primary
pickup-group 1
label
name MainOffice Two
call-forward busy 500
call-forward noan 500 timeout 20

[Brandon Buffin · Accepted solution]

The two commands you mention are valid when using ephone-hunt configuration (SCCP phones only), but not in voice hunt-group config (SCCP, SIP, PSTN, etc.).

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/command/reference/cme_cr/cme_m1ht.html#wp9533787070

Brandon

[johnsnave1]

Many thanks for your prompt and very helpful reply.

[Rob Huffman]

Hi John,

EDIT: +5 to my friend Brandon for his great tips here!

On the first error screen I think the problem is with the word Max and on the second error screen I think the error is with the comma between 5,5. Can you try;

(config-voice-hunt-group)# timeout 5