CME is showing its connected to 2 ext IP address on same interface
I have rebooted our CME today as we were having some minor issues but I have found that it is doing something quite odd. It believes that 2 external IP addresses are configured on a single interface, which has an ACL on it.
When I issue a sho ip route, i see that it believes there are 2 external IP addresses on the same interface, although when i issue a sho run int g0/2 (the ext interface) I see that only one is configured.
This is creating a headache becuase the other IP is used by our ASA for our phone VPN connection, which currently cannot work.
Any thoughts as to what could be causing this or is it a case of reboot and see.
We have CUCM and CUC (v12.5) which has been directly registered to Cisco's Smart Licensing, but today's I noticed this error from RTMT "Smart Licensing Authorization Renewal Failure". I tried to force the re-authroization and re-registration and now it sa...
Hello I have a Cisco 7841 3pcc Phone, if I specify a custom ringtone and try to play it, it is spit out in the log> Bad parameter in Ring File field: w = tftp: //192.168.220.120/TEST.rawand the standard sound plays.-----------4047 ERR Jan 17 16: 15: 33...
Please rate helpful content (i.e. videos, documents, comments). Also, please select the correct answer(s) if any comment(s) answer your question otherwise the questions remains on the support forums as unanswered.
The set web-security CLI command...