CME ISR4321, ucse subslot does not start automatically after powerON

[alig.norbert]

CME ISR4321, ucse subslot does not start automatically after powerON

Hi all,

Got an ISR4321 with UCS-EN140N-M2 for CUE.
Unfortunately the ucse subslot will not boot automatically after reboot or power on.

When I execute the CLI "ucse subslot 0/1 server start" it boots.

Tried EEM with no success:

event syslog pattern "SYS-5-RESTART"
action 1.0 wait 60
action 2.0 cli command "ucse subslot 0/1 server start"

action 6.0 syslog msg "UCSE START AFTER REBOOT"

Tried several IOS version:

- isr4300-universalk9.16.06.06.SPA.bin
- isr4300-universalk9.16.06.04.SPA.bin
- isr4300-universalk9.16.06.02.SPA.bin

Any ideas?

Thank you,

Norbert

[Vaijanath Sonvane]

Hi,

As per Installation Guide and Data Sheet, the Cisco UCS E-Series NIM NCE (i.e. UCS-EN140N-M2/K9 ) is supported on Cisco IOS XE Release 3.15S and later releases or XE 16.2.1. Here are the URLs for your reference:

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/gs/guide/b_Getting_Started_Guide/b_3_x_Getting_Started_Guide_chapter_011.html#con_1061306

https://www.cisco.com/c/en/us/products/collateral/servers-unified-computing/ucs-e-series-servers/data_sheet_c78-705787.html#SystemRequirements

Have you tried these IOS releases?

[alig.norbert]

Hi,

Thanks for you reply.

I'm with TAC to find a solution. The UCSE works properly, only when the ISR boots the UCS will not start automatically.

Regards,

Norbert

[janower4652]

Hi. Did you manage to get this resolved?
I'm experiencing the same issue with an ISR4331 with a UCS-E 160S-M3 server. It only boots the CIMC, but the server doesn't. I have to go into the CIMC and boot the server from there.

Also, I have checked at the power policies configuration page, and the "restore last state" is selected, so the server should boot up after reloading the router.

Thanks.