CME Presence with Extension Mobility

[Felix Sarayar]

Hello,

I have a CME 8.6 running on a 2811 ISR.

It is currently configured with Extension Mobility. Phones are all 7960.

I want to implement presence and have followed the admin guide to do so, but I've come across a problem

blf-speed-dial command.

When trying to do this under ephone<tag> it says

"Please configure under logout profile for em enabled phone"

How does this work when it's configured for the logout profile and not the user profile?

I did try and configure it under there and it does not do anything.

btw I only have 1 logout profile for the entire system.

Regards

Felix

[ronpatel · Accepted solution]

Hi

The BLF is to be configured in Logout profile only. See below link and see section "Configuring a Logout Profile for an IP Phone"

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmemobl.html

Command is

speed-dial speed-tag number [label label] [blf]

Regards

Ronak patel

Please rate helpful posts by clicking stars below the answer.

[Felix Sarayar]

Hi Ron,

So in CME the phone appearance is a combination of

1) the voice user-profile

AND

2) logout profile

Which means I should have a unique logout profile for each user who is on EM and wants BLF?

Regards

Felix

[Felix Sarayar]

Just to add that this is now working.

When you configure the BLF under the logout profile it "adds" it in the voice user-profile.

you can see the change when doing a show run, that the blf speed dial commands now appear under the user-profile.

Thanks

Felix