Good day all! So this is for 2 things. First my study purposes and secondly to test CME for this company. The test router is a 2821 with an VWIC2-2MFT-T1/E1 and an NM-HD-2VE . We have an old Comdial PBX that we are currently using. (This is what will be replaced eventually.) I have the 2821 all setup to send calls out the PRI side (our t1 is 12 lines so 1-12) but for the life of me I can't figure out what configuration I would need to use for the PBX. I figured I would just setup the second t1 (1/0/1) with the reset of the lines (13-24) and I should be able to at least reach the other lines. Nothing but busy with the dial pattern 1.. (100 is the extension range for the PBX and 200 is the CME).
I know that's an overlapping dial-plan to the 91[2-9]..[2-9]...... but I get the same results with it removed. The CME will be holding extensions 2xx and the pbx will keep 1xx. I basically want the CME to pass all incoming through to the PBX but allow the CME extensions to dial out and reach the PBX extensions. Can anyone point me in a little better direction? I have attached a basic diagram.