cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

AMA-CUCM Troubleshooting: Best Practices for Reading Trace Files

143
Views
0
Helpful
1
Replies
Beginner

Collecting CDRs and Utilization report from CUBE

Hello Folks,

 

We want to collect CDRs of SIP calls from CUBE. Is there anyway to do this ? 

 

Also for capacity planning, we have been unsuccessful to receive trunk utilization report from ITSP so we would like to explore if there is any way to capture SIP trunk utilization from the CUBE interface connected with ITSP SBC ? 

 

I was referring to this article to collect CDR (https://community.cisco.com/t5/service-providers-documents/collect-cdr-from-cisco-voice-gateway-into-a-realtime-database/ta-p/3107636) but I am not sure if it is applicable for CUBE as well. Our CUBEs are on IOS XE 16.10.1a version. 

 

Thank you for help in advance. 

Everyone's tags (2)
1 REPLY 1
Highlighted
Rising star

Re: Collecting CDRs and Utilization report from CUBE

You can enable accounting or similar but it has a CPU impact . RADIUS is one option as it cannot send CDR to the UCM, but in a later version only CMR.

There is a call establishment rate type SNMP OID , but it’s not specific to which peer if you have many.

That’s as far as I’ve gone with it, the ISR G2 is far more sensitive to this sort of thing and will tank the CPU than Id thought
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards