Conference Call Between Call Manager Express and CUCM

[cigalahgroup]

Hello,

           I am able to do a conference CME 7.0. 

Scenario:

1234 is calling 6789 and wants to include 6788 in the conference but it cannot. 

[Chris Deren]

Are you using software or hardware conferencing, can you post your CME Guide?

Is there both CME and CUCM registered phones involved as your title stated as such? If so, who is initiating the conference, CME or CUCM phone?

[cigalahgroup]

I am bit new to ip telephony please bear with me ..  Hardware  conferencing means using conferencing machines ? If yes then I dont have any. I want to use the software based adhoc.

What I know is cme is not enabled to do so ? I need to first enable the feature in CME .

[Chris Deren]

Post "show run".

Have you had a chance to read through the CME admin guide conferencing chapter:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm/cmeconf.html

[cigalahgroup]

Chris I have read that but its asking about DSP I need to find those if its there I have 3825 router, check this if u need 

Router#sh inventory
NAME: "3825 chassis", DESCR: "3825 chassis"
PID: CISCO3825 , VID: V05 , SN: FTX1353AJ3K

NAME: "VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 0", DESCR: "VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1"
PID: VWIC2-2MFT-T1/E1 , VID: V01 , SN: FOC135145P5

NAME: "VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 1", DESCR: "VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1"
PID: VWIC2-2MFT-T1/E1 , VID: V01 , SN: FOC13514642

NAME: "One-Port Fast Ethernet High Speed WAN Interface Card on Slot 0 SubSlot 2", DESCR: "One-Port Fast Ethernet High Speed WAN Interface Card"
PID: HWIC-1FE , VID: V01 , SN: FOC14240U44

NAME: "One-Port Fast Ethernet High Speed WAN Interface Card on Slot 0 SubSlot 3", DESCR: "One-Port Fast Ethernet High Speed WAN Interface Card"
PID: HWIC-1FE , VID: V01 , SN: FOC14240U5Q

NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 4", DESCR: "PVDMII DSP SIMM with four DSPs"
PID: PVDM2-64 , VID: V01 , SN: FOC13492DPX

NAME: "AIM Service Engine 0", DESCR: "AIM Service Engine"
PID: AIM-CUE , VID: V03 , SN: FOC13503ETV