cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
223
Views
0
Helpful
1
Replies

configuration CME

Labanelamia
Level 1
Level 1

hello,

I'm configuring CME , During the configuration on access to the PSTN, I faced a problem that is summarized in :

When the CME receives a call from the PSTN, if the caller hangs up before the called pick up the phone, the phone remains ringing indefinitely.

Here is the configuration I made:

-----------------------------------------------------------------------------

  Router>enable

  Router#configure terminal

Router(config)#voice-port 0/0/0

 Router(config-voiceport)#connection plar 9001

Router(config-voiceport)#caller-id enable

Router(config-voiceport)#exit

------------------------------------------------------------------------------------------

 Router>enable

  Router#configure terminal

Router(config)#ephone-dn 11 dual-line

Router(config-ephone-dn)#number 9001

  Router(config-ephone-dn)#name John Smith

   Router(config-ephone-dn)#exit

   Router(config)#ephone 

Router(config-ephone)#mac-address 381C1ABA5C04

   Router(config-ephone)#button 1:11

 Router(config-ephone)#end

----------------------------------------------------------------------thanks--------------------------------------------

1 Reply 1

hsood
Cisco Employee
Cisco Employee

Hi ,

Can you post an output of the following debugs:

debug voice ccapi inout

debug isdn q931 (considering PSTN to be connected via PRI)

Regards,

Hitesh