cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1027
Views
0
Helpful
2
Replies
Gordon Charlton
Beginner

Configuration of DSP Farm on ISRG3 (ISR4331)

Hi,

I wonder if someone can point me the right direction to configure a DSP Farm for an ISR4331 I am setting up for CME.

The command I would have used under the voice card on a G2 is longer supported.

I realise they G3 cards have on-board DSP's, but I am unclear how I access the PVDM4 on the motherboard?

Regards,

Gordon

2 REPLIES 2
Manish Gogna
Cisco Employee

Hi Gordon,

Please check the following link

http://www.cisco.com/c/en/us/support/docs/routers/4000-series-integrated-services-routers/118792-config-isr-00.html#anc8

Manish

Hi Manish,

Thanks for this, however, in this case I have a BRI interface, not PRI.

I can enter:

voice-card 0/1 (the BRI card)

But the DSP command is not available.

Regards,

Gordon

Create
Recognize Your Peers
Content for Community-Ad