10-18-2016 01:42 AM - edited 03-17-2019 08:23 AM
Hi,
I wonder if someone can point me the right direction to configure a DSP Farm for an ISR4331 I am setting up for CME.
The command I would have used under the voice card on a G2 is longer supported.
I realise they G3 cards have on-board DSP's, but I am unclear how I access the PVDM4 on the motherboard?
Regards,
Gordon
10-18-2016 04:02 AM
Hi Gordon,
Please check the following link
http://www.cisco.com/c/en/us/support/docs/routers/4000-series-integrated-services-routers/118792-config-isr-00.html#anc8
Manish
10-18-2016 05:52 AM
Hi Manish,
Thanks for this, however, in this case I have a BRI interface, not PRI.
I can enter:
voice-card 0/1 (the BRI card)
But the DSP command is not available.
Regards,
Gordon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: