Configuring a Linksys 2102 to integrate into Call Manager 6.1

[nowcommsupport]

Hi

I have a linksys 2102 that i have configured in CCM 6.1 as a 3rd party SIP device, it all regsiteres fine, i have an analogue phone plugged into port 1, and that rings and all is great, but i want to plug a bell into port 2 on the linksys 2101, but do not know to make the 2nd port active on the linksys and then to configure it on the CCM?

I have tried configuring like an ATA and swapping the MAC address around but it didnt like that, what i want to happen is for the the Analogue phone and bell to have the same number as well.

anyone got any ideas?

Thanks

Ash

[Mark Pareja]

Your not going to have a whole lot of luck with this one here as this is not a supported configuration, but I did find an interesting post in another fourm that may shed some light on your options with that device.

https://www.myciscocommunity.com/thread/3338;jsessionid=DF0305214117132B8800F3782D544066.node0