cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1506
Views
10
Helpful
7
Replies

Configuring a VG224 for an analog phone

Jim Schewe
Level 1
Level 1

This is my first attempt at doing this so I know that I'm missing something simple. The port is configured as a POTs line but when I put a plain phone on that port, I just get the fast busy signal. Any ideas on where to start? We're running Unified Communications Manager 7.x

7 Replies 7

Jaime Valencia
Cisco Employee
Cisco Employee

Which protocol are you going to use in the VG224?

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

Right now it's MGCP.

Thanks

Jim

Hi Jim,

Is the MGCP gateway registered?

Does the port have dial tone when you put an analog phone?

I just noticed when I go to that port the Registration is showing "Unknown".  When there's an analog phone plugged into that port, there's no dial tone, just the fast busy.

Should the port show a registration and IP address?

The mgcp port needs to be registered.

Can you send me the sh run from the gateway so that i can identifiy what is missing.

Be sure, that stcapp application on the port is enable.

stcapp is for SCCP, not MGCP.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: