cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
368
Views
0
Helpful
1
Replies
bob.bartlett
Beginner

Configuring Transcoding on Cisco 3945

Can you configure transcoding using the Loopback0 interface for the MTP?  If so how do you call it out since it does not have a MAC-Address?                  

1 ACCEPTED SOLUTION

Accepted Solutions

You dont need the MAC address to configure Transcoding. You just need to define the transcoding profile name

Please rate all useful posts

"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson

Please rate all useful posts

View solution in original post

1 REPLY 1

You dont need the MAC address to configure Transcoding. You just need to define the transcoding profile name

Please rate all useful posts

"'Nature is too thin a screen, the glory of the omnipresent God bursts through it everywhere"-Ralph Waldo Emerson

Please rate all useful posts

View solution in original post

Content for Community-Ad

Spotlight Awards 2021