Connect TR1034+P2-1B to Cisco

[metalium2007]

Hello,

I would like to interconnect a Cisco Router ISDN card with Brooktrout TR1034+P2-1B (BRI). Since I need to give L1 clock from the Cisco side, is this a possible scenario?

Thanks!

met

[asandborgh]

Hi,

Yes - see the attached link

http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dtpri_ni.html

HTH,

Art

Please rate if this helps.

[metalium2007]

Hello,

I'm talking about BRI interface. Have you tried it before?

Thanks!

[asandborgh]

oops!

Try this instead

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010ef6c.shtml

[metalium2007]

Thank you very much my friend.

But you think I will not have problems with source clock from Cisco, right? Good Layer1?

Thanks,

met

[asandborgh · Accepted solution]

Hi Met,

I have done this many times with PRI, but never BRI.  It has always worked very well and is easy to set up.  I think if you get the cable right everything else will work very well.

Good luck,

Art

If this helps please rate.

[metalium2007]

Thank you, I'll give it a try.

+5 for the kindness!

met