10-02-2022 12:03 AM
we have two Cisco UCS C220 M4 server's with SBE 6000M Unified Communications Version 11.5
how to connect PRI E1 Trunk line to Server
Solved! Go to Solution.
10-02-2022 12:09 AM
You need a voice gateway basically its a router and the gateway must have an ISDN PRI card. You will terminate the lines on voice gateway. Gateway will talk to CUCM using SIP/MGCP/H323 protocol.
Kindly reach out a local Cisco partner who is good in voice.
10-02-2022 04:09 AM
The server itself has no ability to connect to a ISDN circuit. You’ll need to use a router with the adequate interface type in it for this. Assuming that you are running Communication Manager on your server you’ll have a few different options for how to to interact with the router. Either you set it up as a gateway with either MGCP or H.323 as the control protocol or what is the currently most used option as a trunk that uses SIP as the control protocol. What you use is your preference.
10-02-2022 12:09 AM
You need a voice gateway basically its a router and the gateway must have an ISDN PRI card. You will terminate the lines on voice gateway. Gateway will talk to CUCM using SIP/MGCP/H323 protocol.
Kindly reach out a local Cisco partner who is good in voice.
10-02-2022 04:09 AM
The server itself has no ability to connect to a ISDN circuit. You’ll need to use a router with the adequate interface type in it for this. Assuming that you are running Communication Manager on your server you’ll have a few different options for how to to interact with the router. Either you set it up as a gateway with either MGCP or H.323 as the control protocol or what is the currently most used option as a trunk that uses SIP as the control protocol. What you use is your preference.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide