cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
269
Views
0
Helpful
2
Replies

Connection E1 on VGW was full

I have Router VGW-1 and VGW-2 connected to E1 PSTN "X".

The problem is when connection E1 on VGW-1 was full the next connection from PSTN "X" will forward to VGW-2

then occur people that call from PSTN can't listen to any voice from VGW-2.

How can i show connection on router VGW and what is the couse of problem ?

2013-07-16 16_44_10-Drawing1 - Visio Professional.png

Thank you,

Akekarat Yingjaroen

2 Replies 2

acampbell
VIP Alumni
VIP Alumni

Akekarat

The majority of one way transmission issues on IPT are caused by ip routing issues.

The speech path is between the ip phones and the ip address bound on the gateways.

Please ensure that you have bound an ip address for your protocol (H323 SIP MGCP) on the gateways and that

the Ip routing is set up in both directions betwee the phones default gateways and the voice gateway routers

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

thank you,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: