%CONTROLLER-2-FIRMWARE: Controller T1 0/3/0, firmware is not running

[scottsassin]

I have a 2811 router, running c2800nm-advipservicesk9-mz.124-20.T6.bin.  I have installed a VWIC-2MFT-T1 card.  I get the error above in the title.  Please let me know if we need to order a new card.

[Joseph Martini]

Looks like you may have to reseat the card.  If that doesn't work can you move the card to another slot and see if the problem follows the card or not?

[scottsassin]

Thank you,

I have tried different slots, I have tried different routers, I have tried different IOS versions.  The ports of the card are not hooked up to the PSTN yet.

I have looked all over for the answer, and can not find one.  Should I invest in a new card?

[Faheem Ansari · Accepted solution]

i think you should invest coz same problem i faced two days back, this problem may because of faulty T1/E1 port on Cisco Module.

Regards,

Faheem Ansari

[phooghen · Accepted solution]

Correct, you VWIC-2MFT-T1 is faulty and needs to be replaced or RMA.

Pierre.