hi there,
where we should use auto qos trust cos and where to use auto qos trust dscp.
we had some issues in our network where we can see any cos incoming trrafic in cos 5 but we can see in cos 6 same with outgoing .
which one is right comand to use on uplinks with router and which one is to use with switch uplink.
#sh mls qos int g0/1 statistics
GigabitEthernet0/1 (All statistics are in packets)
dscp: incoming
-------------------------------
0 - 4 : 66471 0 0 0 0
5 - 9 : 0 0 0 0 0
10 - 14 : 0 0 0 0 0
15 - 19 : 0 0 0 0 0
20 - 24 : 0 0 0 0 2064
25 - 29 : 0 20 0 0 0
30 - 34 : 0 0 0 0 0
35 - 39 : 0 0 0 0 0
40 - 44 : 0 0 0 0 0
45 - 49 : 0 3060 0 0 0
50 - 54 : 0 0 0 0 0
55 - 59 : 0 0 0 0 0
60 - 64 : 0 0 0 0
dscp: outgoing
-------------------------------
0 - 4 : 64384 0 0 0 0
5 - 9 : 0 0 0 90 0
10 - 14 : 0 0 0 0 0
15 - 19 : 0 0 0 0 0
20 - 24 : 0 0 0 0 2712
25 - 29 : 0 0 0 0 0
30 - 34 : 0 0 0 0 0
35 - 39 : 0 0 0 0 0
40 - 44 : 0 0 0 0 0
45 - 49 : 0 0 0 995 0
50 - 54 : 0 0 0 0 0
55 - 59 : 0 0 0 0 0
60 - 64 : 0 0 0 0
cos: incoming
-------------------------------
0 - 4 : 67404 0 0 2084 0
5 - 7 : 0 3060 0
cos: outgoing
-------------------------------
0 - 4 : 65088 90 0 2712 0
5 - 7 : 0 995 0
output queues enqueued:
queue: threshold1 threshold2 threshold3
-----------------------------------------------
queue 0: 0 0 0
queue 1: 0 3327 11775
queue 2: 0 0 64483
queue 3: 90 0 2
output queues dropped:
queue: threshold1 threshold2 threshold3
-----------------------------------------------
queue 0: 0 0 0
queue 1: 0 0 0
queue 2: 0 0 0
queue 3: 0 0 0
Policer: Inprofile: 0 OutofProfile:
