cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
553
Views
0
Helpful
10
Replies
Jeylinux4Cisco
Beginner

Could not find kernal image : linux - Error in VMWARE for CUCM 8.0

Hi There,

I am installing CUCM 8.0 on VM ware 9.0, I am seeing this errro once i have given the image from the same laptop.

Could not find kernal image : linux

boot:

Hardware details which I have given in VMWARE:

HDD Size - 40G

Memory - 1 G

Thanks & regards,

Bala

1 ACCEPTED SOLUTION

Accepted Solutions

Hi Bala,

Please use a bootable image and it should work fine.

Regards,

Harmit.

View solution in original post

10 REPLIES 10
Harmit Singh
Cisco Employee

Thank you..

My pleasure Bala, good luck! :-)

Regards,

Harmit.

Hi Harmit,

I have the config and spaces as mentioned in the above links. But Still getting the same error. Is there any other step to fix this issue?

Thanks,

Bala

Hi Bala,

The specs you mentioned are not enough:

HDD Size - 40G

Memory - 1 G

Double both of them and it should hopefully go through fine. Refer to the table at the bottom about the memory and disk requirements for different server models just to give you an idea:

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html

HTH.

Regards,

Harmit.

Hi Harmit,

Yeha, I have chnaged to 80G for HDD and and 1.5GB for RAM, Still i am getting the same error.

Also for your information that, Same ISO image is working fine on another Virtual machine that is PUB01.

Am trying to install PUB02. I am getting the error in the subject,,

Thanks!!

Regards,

Bala

Hi Bala,

That error normally points to a bad image. Try deleting the VM and creating it again with 80GB HDD and 2GB RAM. Make sure you have enough resources on the machine where you are trying to install this VM.

Regards,

Harmit.

Hi Bala,

Please use a bootable image and it should work fine.

Regards,

Harmit.

View solution in original post

Hi Harmit,

I am happy to inform that, it worked finally, Thanks for your time and suggestion..Follwing steps have been taken..

1.Increased the RAM to 4GB

2.Created a bootable ISO file.

Thanks & regards,

Bala

Hi Bala,

Excellent, glad to know it's working now :-)

Regards,

Harmit.

Content for Community-Ad

Spotlight Awards 2021