CP-7911G Wall Plate Mount

[blackmichael]

I am trying to mount a 7911 phone to the wall using a standard wall plat.  Apparently the holes do not line up.  Does anyone know of a wall plate in which the 7911 can mount flat on the wall?

The Cisco locking wall bracket is not good for my application and since it tilts the phone up.

[Rob Huffman]

Hi Michael,

The spacing of the Back-side mounting holes enables direct mounting

to the Electrical box, no Mounting plate is required

Cheers!

Rob

[blackmichael]

Is there a specific screws to use for the best fist?

Also is there a plate i can use to mount the RJ45 port behind the phone so its not an empty electrical box.

[Rob Huffman]

Hi Michael,

The mounting holes are pretty forgiving and will work with

a number of Screws. We found the "best" fit was to use

a 1mm x 1mm (round head Phillips)

I have not seen a Mounting plate that would work within an

electrical box We are an "Amp" cabling infrastructure

shop, so a Part# like the following worked well within the

box ;

http://www.ampnetconnect.com/product_cut_sheet.asp?pn=137519100

Cheers!

Rob