cptone RU parameters???

[e_kniazev1974]

Hi ALL!

Where I can find parameters which Cisco using in standard cptone RU?

These is the following:

dualtone busy - what frequency and cadence?

dualtone ringback- what frequency and cadence?

dualtone disconnect- what frequency and cadence?

I can't find it on cisco.com :(

Thank a lot.

[virverma]

check this link,

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t2/feature/guide/ft_ansds.html#wp107237

[e_kniazev1974]

Thanks.

I found this link early

but unfortunately I can't in this document

what parameters of freq/ and cadence Cisco mean when configure voice port

by command

cptone RU

[Nicholas Matthews]

I think this is what you're looking for:

test voice tone RU show

Here's output:

nicmatth-sip#test voice tone RU show

Code: RU Country: Russian Federation

DTMF freq.(Hz) Row / col: 697, 770, 852, 941 / 1209, 1336, 1477, 1633

Pulse dial: normal, Percent make: 35%, DTMF low Amp. = 65446, high Amp. = 65446, Pcm: a-Law

Tone NF FOF FOS AOF_FXS AOF_FXO AOF_EM AOS_FXS AOS_FXO AOS_EM ONTF OFTF ONTS OFTS ONTT OFTT ONT4 OFT4

BUSY 1 425 0 -200 -200 -200 0 0 0 500 500 0 0 0 0 0 0

RING_BACK 1 425 0 -100 -100 -100 0 0 0 800 3200 0 0 0 0 0 0

CONGESTION 1 425 0 -200 -200 -200 0 0 0 250 250 0 0 0 0 0 0

NUM_UNOBTAINAB 1 425 0 -200 -200 -200 0 0 0 250 250 0 0 0 0 0 0

DIALTONE 1 425 0 -150 -150 -150 0 0 0 65535 0 0 0 0 0 0 0

DIAL_TONE2 1 425 0 -150 -150 -150 0 0 0 65535 0 0 0 0 0 0 0

OUT_OF_SERVICE 1 950 0 -150 -150 -150 0 0 0 330 330 0 0 0 0 0 0

ADDR_ACK 1 600 0 -240 -240 -240 0 0 0 125 125 125 65535 0 0 0 0

DISCONNECT 1 600 0 -150 -150 -150 0 0 0 330 330 330 65535 0 0 0 0

OFFHOOK_NOTICE 1 425 0 -200 -200 -200 0 0 0 500 500 0 0 0 0 0 0

OFFHOOK_ALERT 1 425 0 -200 -200 -200 0 0 0 500 500 0 0 0 0 0 0

-nick