Critical Error : CUCM 9.1.2 Installation failed with return-code 256

[Fikri FIRAT]

Hi all,

The installation aborted with the following error message, any ideas on why this could happen? How can I access the mentioned path? How can I get the dump logs?

[Jaime Valencia]

What HW are you using?

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

[Fikri FIRAT]

Hi Jaime,

I'm using Vmware v8, but didn't deploy with .ova from cisco.

Regards,

Fikri

[Jaime Valencia]

Then, you should be using the OVA from Cisco, and that's not HW what you just replied.

I'll take it you're running ESXi 5 from the V8, but again, that does not answer the question, that's not HW.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

[Fikri FIRAT]

Hi Jaime,

Sorry for my answer, I find it hard to focus at these hours sometimes :(. I believe what you are asking is the general specs of the VM :

[Nirmal Joshi]

what server are you using? Is it ucs c220 or some third party server?

[Sushant Sharma]

Hi I have also same issue.

i am runing ucs c200 M2 server .

Esxi 5.0

After taking a  two-three hours not able to install getting same issue.

d