cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
320
Views
0
Helpful
6
Replies

CSS error

mymite060708
Beginner
Beginner

CM version 4.1-3

I have an issue with a CSS.

CSS_PRI has two partitions

PT_private

PT_ALL

I have about 100 phones with the DN in PT_ALL and a CSS of CSS_PRI and thy can all call each other fine.

one of the phones in PT_ALL can not be dialled by other phones with the CSS of CSS_PRI. Just get NU

it only works if I create a Translation pattern for the number in PT_private and forward it out with a css they does not include the PT_private partition

so for some reason when dialling this one extension the css must see the number in the PT_private partition. I have searched cm and can't find any instance of it in that partition could it be stuck somewhere?

thanks

6 REPLIES 6

jbarcena
Engager
Engager

Is it the same DN? for example 1000 in PT_private and 1000 in PT_ALL ?

If that is your case then is working as designed you will only reach 1000 in PT_Private and never 1000 in PT_ALL

If that is not our case, then perhaps you could elaborte, include extensions, partitions, css, etc. as much details as possible, it would be better if you could also include a CCM detailed trace of the call.

//Jorge

the DN = 500

PT= PT_ALL

all phones have the CSS that can see PT_ALL

and PT_Private

there is only one instance of the DN 500 and thats in PT_ALL. but phone cannot dial it unless I put the number in PT_Private

like I say its only this one number all other phones are the same.

trace file on its way

Have you confirmed through the route-plan report that there is no orphan DN500 other than that in PT_ALL?

You should only see one instance, not including the translation if present. There is a DN500 that is not associated with the phone, and is not the translation then you should delete, it should not be active anyway.

Hope this helps

Allan.

hi

checked all CM and there is not orphan DN500 anywhere, looking through the CCM trace I can see the following line

"Found intercept table entry for DN = 500:PT_Private"

so it look like CM still thinks DN:500 is in the PT_Private PT

how do I remove this?

Go to the Route Plan Report and make a search for all the patterns that contain 500.

As suggested you should also check if you do not have orphan DN's, in the same report you can make a search for unassigned DN's, delete all the results.

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

usually info stays in cache, i'd suggest a reboot if you have already checked there are no other 500 DN within the dial plan

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: