01-10-2012 05:33 AM - edited 03-16-2019 08:54 AM
01-11-2012 10:37 AM
Hi Mike,
Sorry it took a while for a response! I had to search it out as it isn't an area that I'm well-versed in. Gen4 can replace Gen3. There is a minimum CTS software version requirement. We are searching out that information for you right now.
Regards,
Julie Swenson
02-07-2012 09:39 AM
We recommend CTS1.8 software or later for the Gen4 displays on the CTS products. Thanks!
02-07-2012 09:55 AM
Sorry! The "Guest" reply above was my comment. The recommended software to run with the GEN4 displays on a CTS system is CTS1.8 software.
Thanks!
Julie
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: