The title may be somewhat misleading, but I am running into an issue with our CUBE. We own an entire NXX, originally on PRIs and slowly moving it over to ATT IP Flex. Some of our numbers from our NXX have been ported to our corporate phone system separate from us. Calls across the PRI gateways go through no issue, but calls across the CUBE to ISTP timeout after around 20 seconds and the provider is getting a Q.850;cause=102 as the reason for disconnect.
When the call originally goes through, I can hear the recorded greeting and after about 20 seconds I get a busy signal and then am disconnected. From looking at the traces on the CUBE it seems as if it goes through and then the CUBE is trying to send INVITEs to each of the Call Manager servers in the middle of the call, which receives 404s as it is no longer built on the Call Manager side. I can then see the reason code that the provider sent me as well. Below is a call flow example and the current applicable CUBE config. What am I missing here?
Call Example: 2055556789 dials 92055551515, call routes and hear the recording greeting, call gets busy signal after 20 seconds and drops after about 30 second total duration.
voice service voip
no ip address trusted authenticate
address-hiding
mode border-element license capacity 160
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
no supplementary-service sip handle-replaces
redirect ip2ip
signaling forward unconditional
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
no fax-relay sg3-to-g3
sip
bind control source-interface Loopback1
bind media source-interface Loopback1
header-passing
error-passthru
asserted-id pai
early-offer forced
no silent-discard untrusted
midcall-signaling passthru
privacy-policy passthru
g729 annexb-all
!
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8 bytes 30
codec preference 3 g711alaw
!
voice class e164-pattern-map 100
description Incoming Call Pattern Map 100
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXXX
e164 205XXXXX[0-2]
e164 205XXXXX[01]
e164 601XXXXX[2-6]
e164 205555....
!
!
voice class e164-pattern-map 200
description Outgoing Call Pattern Map to ATT-SBC 200
e164 1205[2-9]......
e164 011T
e164 205[2-9]......
e164 1[2-9]..[2-9]......
e164 [2-9]..[2-9]......
!
!
voice class server-group 1
ipv4 X.X.X.76
ipv4 X.X.X.77
ipv4 X.X.X.78
description CUCM Servers
!
voice class server-group 2
ipv4 IP-1
ipv4 IP-2
description ATT-SBC
!
voice class sip-options-keepalive 1
description OPTIONS PING to ATT-SBC
transport udp
dial-peer voice 100 voip
description INBOUND SIP from ATT-SBC
call-block translation-profile incoming Block-Incoming
call-block disconnect-cause incoming call-reject
session protocol sipv2
session transport udp
incoming called e164-pattern-map 100
voice-class codec 1
voice-class sip bind control source-interface GigabitEthernet0/0/1
voice-class sip bind media source-interface GigabitEthernet0/0/1
dtmf-relay rtp-nte
no vad
!
dial-peer voice 101 voip
description OUTBOUND SIP FROM CUBE TO CUCM
session protocol sipv2
session transport udp
session server-group 1
destination e164-pattern-map 100
voice-class codec 1
dtmf-relay rtp-nte
no vad
!
dial-peer voice 200 voip
description OUTBDOUND SIP to ATT-SBC
session protocol sipv2
session transport udp
session server-group 2
destination e164-pattern-map 200
voice-class codec 1
voice-class sip options-keepalive profile 1
voice-class sip bind control source-interface GigabitEthernet0/0/1
voice-class sip bind media source-interface GigabitEthernet0/0/1
dtmf-relay rtp-nte
no vad
!
dial-peer voice 1 voip
description Incoming VOIP Dial-Peer
incoming called-number .
voice-class codec 1
dtmf-relay rtp-nte h245-alphanumeric
no vad
gateway
timer receive-rtp 1200
!
sip-ua
no remote-party-id
timers options 1000
connection-reuse
