03-01-2013 03:16 AM - edited 03-16-2019 04:00 PM
Hi there,
My customer orignally deployed 2 x CUBEs in an Active/Standby HSRP configuration using the CUBE Redundant licence.
He now wants to move one of the gateways to another data centre in an Active/Active configuration so will need full CUBE licending on both gateways.
So currently he as the following CUBE licences;
- CUBE #1: FL-CUBEE-100-RED
- CUBE #2: NO CUBE LICENCE
Is there an upgrade licence available to take both of the gateways to full CUBE licencing?
Does the FL-CUBEE-100-RED licence allow full CUBE capabilities on CUBE #1 in an active/active config? In which case perhaps I just need to buy a full CUBE license (FL-CUBEE-100) for CUBE #2? Though this seems a but unfair commercially as the customer will end up paying more for their CUBE than if they just went for full CUBE on both gateways from the start...
Any advice welcome.
Cheers,
Mike.
03-01-2013 08:09 PM
Hi Michael,
Below is the guide:
Some detail information:
FL-CUBEE-XXX licenses apply to the Cisco 2900 and 3900 series ISR G2 routers
++ The ISR G2 routers have additional features, such as box-to-box redundancy
FL-CUBEE-XXX-RED license enables the purchased session count for both platforms, e.g. the FL-CUBEE-100-RED purchased for two Cisco 3945 routers enables a 100-session SIP trunk on both the Active and Standby routers
- Applicable on the router that is Active at one time
++ Now if customer wants to use Active-Active that means, the FL-CUBEE-XXX-RED is not a valid license and does require to purchase the normal single-use session license
OR consider the below:
- CUBE #1: FL-CUBEE-100-RED *** This can be used as normal single-use session license and RED is additional on top
- CUBE #2: NO CUBE LICENCE *** This will require normal single-use licese and wont have the RED additional feature which is not required anyways ***
Hope the above is informative and helpful. And please do bear in mind this is feature license and its subjective to feature
++ Once you have normal feature license, you are good to start using that feature and any additional need to be topped up !
Regards
Prashanthi Velpula
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide