01-29-2014 09:25 AM - edited 03-16-2019 09:30 PM
Hi all,
Do you know if Cube is supported in an environment with redundant Geth ports going to separate VLANs ?
i.e.,
-------------Inbound SIP Trunks ----- GE0/1 -Cube - Ge1/0 ------- VLAN 1 |
|_Ge0/2_____________ VLAN2 | _________CUSP, CVP, UCCE,
01-29-2014 12:04 PM
It's doable, but what what be the reason for doing this?
Chris
01-29-2014 12:08 PM
Thanks Chris, The reason for this is to eliminate a Single Point of failure from the Cube to the ethernet switch. If one switch port fails, we'd have a backup.
01-29-2014 12:16 PM
If the CUBE is connecting to the same layer 2 then use Etherchannel, if separate networks then use loopback interface and utilize routing protocol.
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: