cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
359
Views
0
Helpful
1
Replies

CUCM 10.5 - No Call Diagnostic data in CMRs - fields blank

Randall White
Participant
Participant

I started looking at my Call Management Records in CUCM 10.5. I am getting information like Record Type and Call ID info, but the performance counters are blank. The information I want is Packets Sent / Received, Jitter, Latency, etc. These fields are not '0', they are empty.

I set the "Call Diagnostics Enabled' parameter to 'Enabled Regardless of CDR Enabled', and CDRs are enabled.

What other configuration is needed?

Most of my phones are SIP, 88XX running firmware 12-5-1. Most calls are to/from the PSTN through CUBE to the ITSP.  But even internal phone to phone calls don't show the CMR performance data.

I have searched the documentation, any ideas?

 

Thanks, Randy

 

1 Accepted Solution

Accepted Solutions

Randall White
Participant
Participant

The problem was that 'Load CDR Only' was checked in CAR tool under System > Scheduler > CDR Load

View solution in original post

1 Reply 1

Randall White
Participant
Participant

The problem was that 'Load CDR Only' was checked in CAR tool under System > Scheduler > CDR Load

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers