cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2998
Views
10
Helpful
4
Replies

CUCM 10.5 with MRA - No audio

Anas Abueideh
Level 9
Level 9

Dear Experts,

Kindly find the below Topology with Software versions mentioned.

I have an issue with Jabber phone logging from outside using Cisco Expressway.

The Jabber phone is logging in and authenticate. the user can chat with users.

When the Jabber call other people. It will ring, once we answer the call, there is no audio.

We check the firewall there is no blocking.

Any idea about this situation ?

Waiting for your help

Thanks in advance

Anas

1 Accepted Solution

Accepted Solutions

Did you configure your public ip/NAT ip on the express way-E?

 System>IP on the Expressway-E there is a box called 'IPv4 static NAT address' and you must populate that with your Public IP of the Expressway-E.  It will require a reboot under Maintenance>Restart Options to take affect

Also,

ExpressWay C should only communicate with public IP of expressway E, hence NAT reflexion comes in play and you need to configure this at Firewall side.

Please rate all useful posts

View solution in original post

4 Replies 4

Ayodeji Okanlawon
VIP Alumni
VIP Alumni

How have you setup your expressway-e? Are you using a single NIC or dual NIC?

Are you using NAT IP on your expressway-E ?

Does your firewall has SIP inpection turned off?

Please rate all useful posts

Hello Aydoeji,

I am using Single NIC and I am using NAT.

SIP inspection is turned off on the firewall.

Regards

Anas

Did you configure your public ip/NAT ip on the express way-E?

 System>IP on the Expressway-E there is a box called 'IPv4 static NAT address' and you must populate that with your Public IP of the Expressway-E.  It will require a reboot under Maintenance>Restart Options to take affect

Also,

ExpressWay C should only communicate with public IP of expressway E, hence NAT reflexion comes in play and you need to configure this at Firewall side.

Please rate all useful posts

Hi Ayodeji,

The static nat is configured on the Express-E.

I think my issue is with the firewall rules. because I am configuring the communication between EXP-C and EXP-E on the DMZ-ip not Public IP.

I will check that and I will get back to you 

Thanks

Anas

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: