cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1068
Views
5
Helpful
4
Replies

CUCM 11.5.1.12900-21

Vijay Patil
Level 3
Level 3

We are using CUCM version 11.5.1.12900-21, getting & RTMT alert about "LogPartitionLowWaterMarkExceed " attached is the snap shot for the same ...how do we resolve this issue so that stopped getting & RTMT alerts...

 

is there any cisco documents to resolve this issue

 

 

1 Accepted Solution

Accepted Solutions

If you look into the links that have been shared earlier in the post, that would help.

Regards
Abhay
Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle

View solution in original post

4 Replies 4

LogPartitionLowWaterMarkExceeded : This indicates that the available disk space is low on the log (Common) partition.

It is a very common issue,find the below link helpful to get this resolved.
https://supportforums.cisco.com/t5/uc-migrations/logpartitionlowwatermarkexceeded-cm-10-5/td-p/2698498

HTH
Regards
Abhay

Kindly rate all helpful posts !!!
Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle

HEllo,

 

We installed the COP file for disk space free...after the COP file installation Inactive partition space become free...but the Active & Inactive is showing the same ...how can we reduce that

If you look into the links that have been shared earlier in the post, that would help.

Regards
Abhay
Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle