06-02-2018 12:27 PM - edited 03-17-2019 12:56 PM
Placing a call from one UCM 11.5 cluster to the next the call fails. The phone rings on the other end the call is dead. The setup..... CUCM 11.5 <SIP Trunk> CUBE<SIP Trunk> CUCM 11.5 using two 7965 (SCCP) on both ends.
Attached is the sdl trace, debug ccsip error and debug ccsip messages.
Any help is appreciated.
06-06-2018 06:56 AM
06-06-2018 09:30 AM
Ok. Pass. Just check that you are pinging from interface 302
i imaging you are learning about the x.64.x route from ospf.
06-06-2018 10:52 AM
Also, the call is negotiating to iLBC for the codec. Make sure that codec is supported on both CUCM servers. Better yet, remove iLBC as a choice and only allow g711/g729 unless you specifically need iLBC.
I've seen negotiations to iLBC cause some weird behavior, not sure why.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: