cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

134
Views
0
Helpful
2
Replies
Highlighted
Beginner

CUCM 12.5 call come in, but not out

Hey all, we had to replace our router with a  T1 module attached we use to go outside on calls.  I've configured everything the same, calls now come in but cant go out.  When attempting to call out you get a busy signal.  The router has a T1 module attached with two ports, both are registered at the gateway in the call manager.    Anything obvious I can look at? Call manager and router are setup same as they were before.  I have Route Group/list/patterns configured.  No partitions anywhere.  According to the route pattern, dialing 99 and a number should go straight to the gateway that's registered, but we just get busy signals.  I don't know what else to look at. Untitled.png

1 ACCEPTED SOLUTION

Accepted Solutions
Beginner

Re: CUCM 12.5 call come in, but not out

Solution: Delete everything and re-add.

View solution in original post

2 REPLIES 2
Hall of Fame Cisco Employee

Re: CUCM 12.5 call come in, but not out

What does the debugs show?

HTH

java

if this helps, please rate
Beginner

Re: CUCM 12.5 call come in, but not out

Solution: Delete everything and re-add.

View solution in original post

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here