cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
401
Views
0
Helpful
4
Replies
Highlighted
Beginner

CUCM 5.1 3 selecting audio port range IP comminicator

We are implementing IP Communicator for agents over the wan and wish to restrict the RTP audio. Below is a Cisco link that informs it can be done in CallManager as well as the communicator. However, I cannot find this option in the CUCM, Can anyone help

http://www.cisco.com/en/US/docs/voice_ip_comm/cipc/2_0/english/administration/guide/CADcfg.html#wpxref74880

Thanks

Simon

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Community Legend

Hi Simon,

When you configure IP Communicator in CUCM have a look at the Phone Configuration page, down towards the bottom. You will see;

Product Specific Configuration

and then these two options;

RTP Port Range Start

RTP Port Range End

Hope this helps!

Rob

View solution in original post

4 REPLIES 4
Highlighted
Hall of Fame Community Legend

Hi Simon,

When you configure IP Communicator in CUCM have a look at the Phone Configuration page, down towards the bottom. You will see;

Product Specific Configuration

and then these two options;

RTP Port Range Start

RTP Port Range End

Hope this helps!

Rob

View solution in original post

Highlighted

Thanks for this Rob

All the best

Simon

Highlighted
Hall of Fame Community Legend

Hi Simon,

You are most welcome my friend :)

Cheers!

Rob

Highlighted

Hi,

Is there any way of reducing the RTP port range globally on the CM, as opposed to just on the softphone phone configuration.

So that one could force a standard phone like a 7940 to only use a specific port range.

Thanks