CUCM 8.5 Local Syslog set to Error (3) default but RTMT showing Informational (6) and higher alarms
I have several CUCM systems all running ver. 8.5. The Local Syslog configuration in Unified Serviceability was left at the default value Error (Severity Level 3) yet for all systems the Local Syslog Viewer in RTMT is showing alarms as if the Local level was set to Informational (Level 6) ie. I am seeing all alarms from Informational (6) through Emergency (0)!
This is true for the Syslog messages in both the Local Syslog and the Alternate Syslog.
Also, even though I have not selected 'Exclude End Point Alarms' in Seviceability-->Alarm Configuration-->Service Group-->CM Services-->Service-->Cisco CallManager, I'm seeing that the phone-related endpoint alarms are already going into the Alternate Syslog!
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...
You can use the CLI command 'show risdb query sip' to check the status of SIP Trunks on Cisco Unified Communications Manager (Unified CM, CUCM).
admin:show risdb query sip
----------- SIP Information -----------
Number of SIP entries: 1
I am currently working on separating our Contact Center users from our Corporate Users via LDAP Custom Filters so that we can apply specific Feature Group Template to our Contact Center users and a specific template to our Corporate users. I did not...