I had a working scheme: CUCM - h323 GW - IPtoIP - h323 GW SP
But resently something happened: now simultaneously I have only 3 active calls through my provider's GW. Fourth,
fifth and next calls drops by timeout.
I didn't change Locations in CUCM, by default - unlimited.
Then the call is unseccessful, RTMT shows ( 47 ) Resource unavailable, unspecified.
But I have free DSP resurses.
IOS version on my GW - 15.1(4)M2
It seems that while 3 calls are in progress, GWs can't understand each other over h245 about next call. They can't find adress and port for date transfer (RemoteMediaIPAddress=0.0.0.0 RemoteMediaPort=0). And at the same time CoderTypeRate=g729r8 pre-ietf, but I don't use this codec.
Providers GW IP - AAA.BBB.CCC.DDD
My GW IP - 10.10.10.72
My GW Loopback - 10.255.255.10
There is a calling number translation in IPtoIP settings. All calling numbers translates to 8YYYYYYYYYY
188.8.131.52 - CUCM Publisher
184.108.40.206 - CUCM Subscriber
Calling number - 8XXXXXXXXXX
There are logs of "lucky" and "unlucky" calls in attachments:
NIM-PVDM is the Next-generation digital signal processor (DSP) module with an onboard DSP daughter card which eliminates the need to procure an additional T1/E1 NIM card in order to utilize a PVDM4 chip for IP media services. This module enables the new C...
QuestionGood morning. I am looking for the equivalent of the System Manager Guide Supplement for the SS7INNIC as found on the UCCE CallRouter. Specifically, There should be a table for the EMSUserData Mapping so I can drill down on specific informati...
Hello guys,As I have read the Facebook messenger could integrate with UCCX to handle chat as webchat support,. there is a webhook on Facebook that instructed us to write the CCP URL with HTTPS as a Callback URL after writing the tokens from UCCX to FB and...