cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
480
Views
0
Helpful
1
Replies

CUCM 8.6 h323 GW only 3 active calls

Sergey Dudanets
Level 1
Level 1

Hello.

Can anyone please help me

I had a working scheme: CUCM - h323 GW - IPtoIP - h323 GW SP

But resently something happened: now simultaneously I have only 3 active calls through my provider's GW. Fourth,

fifth and next calls drops by timeout.

I didn't change Locations in CUCM, by default - unlimited.

Then the call is unseccessful, RTMT shows ( 47 ) Resource unavailable, unspecified.

But I have free DSP resurses.

IOS version on my GW - 15.1(4)M2

It seems that while 3 calls are in progress, GWs can't understand each other over h245 about next call. They can't find adress and port for date transfer (RemoteMediaIPAddress=0.0.0.0 RemoteMediaPort=0). And at the same time CoderTypeRate=g729r8 pre-ietf, but I don't use this codec.

Providers GW IP - AAA.BBB.CCC.DDD

My GW IP - 10.10.10.72

My GW Loopback - 10.255.255.10

There is a  calling number translation in IPtoIP settings. All calling numbers translates to 8YYYYYYYYYY

1.2.3.4 - CUCM Publisher

1.2.3.9 - CUCM Subscriber

Calling number - 8XXXXXXXXXX

There are logs of "lucky" and "unlucky" calls in attachments:

- deb voice ccapi inout

- debug cch323 h245

- sh call history voice last 1

Also sh run and sh dsp-g all

I already do not what to to, please help...

1 Reply 1

Sergey Dudanets
Level 1
Level 1

The problem was solved only when we with SP changed protocol to SIP.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: