I have tried and tried to register my E20 to the CUCM8.0(3) as a third-party SIP device (advanced) with no luck.
Does anyone have step-by-step for it.
I have configured end-user with username 1000 and digest password 12345
Configured the new device as 3rd party SIP advanced
enabled digest in the device profile
selected the previously created user as digest user
used Standard SIP Profile for the SIP profile
On the E20, I've configured the SIP Profile 1 with
Proxy 1 - IP Address of the CUCM8
Authentication username - 1000
Password - 12345
URI - 1000 (i tried 1000@ip_address_cucm)
And I can not get it to work. Can anyone help with this please. Can you see any issues with my configuration. Thanks
Solved! Go to Solution.
I recently had to setup a Mitel 5224 SIP phone on CUCM 8.5. Here are steps I went through to make it work.
Procedure for setting up a Third Party SIP device with CUCM (Mitel 5224 in this case):
CUCM one-time setup:
1. Create a SIP Profile for the third-party SIP phone which is a copy of the Standard SIP Profile
2. Create a copy of the Advanced SIP Phone Security Profile for the third-party SIP phone and check the Digest Authentication box
CUCM setup per-phone:1. Create the SIP Phone in CUCM as an Basic or Advanced SIP Device
( Basic requires 3 DLU's gives you 1 line. Advanced requires 6 DLU's and gives you up to 8 lines with video)
a. Use the SIP Profile and Security Profile you created earlier
b. Set the phone's digest user to the end-user of the phone
c. Create a line for the phone and note the extension2. Find the end-user you want assigned to a phone in CUCM
a. Set their Digest Credentials (this can be bulk assigned to be the same password for all users but is a security risk)
b. Associate the phone with the end-user normally
Third-party SIP phone setup per-phone (This is specific to a Mitel 5224 so do whatever is necessary for your phone):
a. User ID is the extension in Call Manager
b. User Display name is how you want the phone to display the number/user
c. SIP Authentication User and Password are the end-user's username and SIP Digest password in CUCM
d. SIP Proxy server is the CUCM IP address
e. SIP Registry server is the CUCM IP address
f. Press Apply
From what I read above perhaps your security profile isn't setup correctly? Alternatively, if the Tandberg device doesn't distinguish between the phone username and the authentication username then then the end-user's name in CUCM must also be the extension number. If it does distingush between them you can use the phone username as the extension (do not use the @
Hope this helps.
Not a lot of useful info.
I have tried to get an e20 going on my CUCM 8 also without any success.
The debugs don't show much of anything.
Does anyone have any suggestions to this?
I configured mine for a URI of XXX@IP address
with a username and password that matches a userid in CUCM
and a proxy address of the CUCM
ON the CUCM, I have tried an advanced as well as a basic SIP device.
I have associated the end user to the device.
I can not get this e20 to register at all.
I don't seem to be the only one with this issue