cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
314
Views
0
Helpful
3
Replies

CUCM 9.1.2 - add demo licenses to existing

Hi guys,

Does anybody know what will happen if I add demo licenses for CUCM 9.1.2 in addition to existing permanent licenses? Is it possible and working solution? The goal is to extend the number of existing licenses for short period of time until additional permanent licenses will be purchased.

Thanks!

Kind regards,
Andrew C.       

Kind regards, Andrew C.
1 Accepted Solution

Accepted Solutions

Hi Andrew,

I doubt you can do it again since you have already exceeded the 60 days period.

Try deleting them for Call manager and add them, re-synchronise , if it helps .

you can refer the link

https://supportforums.cisco.com/message/4152401#4152401

regds,

aman

View solution in original post

3 Replies 3

Aman Soi
Advisor
Advisor

Hi Andrew,

I think , there is no need of adding demo licenses.

After u are finished with permanent licenses and you add more device , it would run for 60 days .You can buy additional licenses and upload  till that time it would show as Non-Compliance in ELM.

regds,

aman

Hi Aman,

But what if the non-compliance period is already expired? What will happen after adding the demo licenses?

Kind regards,
Andrew C.

Kind regards, Andrew C.

Hi Andrew,

I doubt you can do it again since you have already exceeded the 60 days period.

Try deleting them for Call manager and add them, re-synchronise , if it helps .

you can refer the link

https://supportforums.cisco.com/message/4152401#4152401

regds,

aman

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers