05-31-2010 07:50 AM - edited 03-15-2019 11:01 PM
Hi Guys
I have configured a cluster with two CUCM, 1 Publisher a Subscriber.
How do they work with the concept of just doing my subscriber call control?
Because up till the time I did was the following:
On my Gateway connected to PSTN, I set the following parameters
SCCPs local FastEthernet0 / 0
SCCP ccm identifier 172.16.0.148 1
SCCP ccm identifier 172.16.0.147 2
SCCP
!
SCCP ccm group 1
associate ccm 1 priority 2
associate ccm 2 priority 1
ip dhcp pool VOICE
network 10.10.10.0 255.255.254.0
default-router 10.10.10.1
option 150 ip 172.16.0.147 172.16.0.148
domain-name mydomain.com
dns-server 172.16.0.10 172.16.0.3
lease 30
dial-peer voice 1000 voip
description (SUBSCRIBER)
destination-pattern [1-7] .. $
voice-class codec 1
voice-class h323 1
session target ipv4: 172.16.0.147
dtmf-relay h245-alphanumeric
in vad
a preference
!
dial-peer voice 1100 voip
description (PUBLISHER)
destination-pattern [1-7] .. $
voice-class codec 1
voice-class h323 1
session target ipv4: 172.16.0.148
dtmf-relay h245-alphanumeric
in vad
preference 2
!
So I believe my primary subscriber and TFTP and links are directed first to the 172.16.0.147 (Subscriber).
But when I check all my devices have been registered in Publisher (172.16.0.148)
My configuration is correct, anyone have any tips?
Solved! Go to Solution.
05-31-2010 08:00 AM
The GW config has absolutely nothing to do with where your phones register, that is defined by CUCM config.
What you need is a CUCM group in which you define the SUB as primary server and PUB as secondary.
Then assign this to the device pool from phones.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
05-31-2010 08:00 AM
The GW config has absolutely nothing to do with where your phones register, that is defined by CUCM config.
What you need is a CUCM group in which you define the SUB as primary server and PUB as secondary.
Then assign this to the device pool from phones.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
05-31-2010 08:23 AM
OK
Gateway indicated to determine the control input chamada.Que prioritizes the PUB that is correct?
I'll make the change in my Device Pool and see what happens
Thank you for your help
11-20-2010 10:56 AM
Ok resolveld Guyss!!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide