11-30-2011 02:09 PM - edited 03-16-2019 08:19 AM
Hello everyone.
I would like to know how I can introduce and check the ip phone licenses into the CME in a UC520. I have supported UC500 many times but I have never configured any from 0. Today a co-worker from another branch asked me about that because theoretically I am the expert . I couldn't answer him, and I am looking for information but I haven't found much information about that.
Can anyone tell me o give me some information about install and check lp phone licenses in a UC520.
Thank you very much.
11-30-2011 10:38 PM
There is nothing to install unless you are upgrading to a larger number of phones than the unit was bought with.
12-01-2011 12:05 AM
Thanks for your answer.
My co-worker can't install the phones that he need because the uc500 doesn't have enough licences.
How can I check the number of the licences by CLI command?
and If I have to upgrade new licences. How can I do it?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: